iES10G(F) User Manual
iS5 Communications Inc.
39
Unit) packet to check the RSTP’s current status. Enter a value between
1 and 10.
Forwarding Delay Time
(4-30)
The number of seconds a port waits before changing from its
learning/listening state to forwarding state. Enter a value between 4
and 30.
Path Cost (0:auto,
1-200000000)
The cost of the path to the other bridge from the transmitting bridge at
the specified port. Enter a number 1 through 200000000. A value of 0
specifies auto mode.
Priority (0-240)
Decide which port should be blocked by setting the priority in LAN.
Enter a number 0 through 240. The value of priority must be a multiple
of 16.
P2P
Some of the rapid state transactions that are possible within RSTP are
dependent upon whether the port concerned can only be connected to
exactly one other bridge (i.e., It is served by a point-to-point LAN
segment) or, it can be connected to two or more bridges (i.e., It is
served by a shared medium LAN segment). This function allows the P2P
status of the link to be manipulated administratively. True means P2P
enabled. False means P2P disabled.
Edge
The port directly connected to end stations cannot create a bridging
loop on the network. To configure the port as an edge port, set the
port to “
True
”.
Apply
Click “
Apply
” to activate the configurations.
Help
Show help file.
NOTE:
Follow the rule below to configure the MAX Age, Hello Time, and Forward Delay Time:
2 x (Forward Delay Time value –1) ≥ Max Age value ≥ 2 x (Hello Time value +1)
