Title
750598 SingleHeater Cassette
Id
Manual EN
Author
Andreas Lundevall
Version
2
13 of 20
Date
2014-09-29
Lamp replacement
8.1
NOTE!
Disconnect the cassette before service.
Remove lamp
1. Loosen the mounting screws at both of the end covers (Torx T20). See picture below.
2. Loosen both of the end covers.
3. Pull the protection out of the slide. The screws for the lamp holders will be accessible.
4. Loosen the lamp end screws (PH2 Chisel) and remove the lamp.
Attach lamp
8.2
NOTE! Do not touch the IRT-lamp directly. Keep the protection paper around the lamp until the fitting is ready.
1. Fix the lamp in one of the Lamp holders. Make sure that the terminal strip gets as far as possible underneath the square clamp. Fasten the screw.
Bend the other lamp end with the finger and fix it as the first one. See picture below.
2. Focus the IRT-lamp by centralizing it sideways in the reflector body.
3. Focus the IRT-lamp by centralizing it lengthways in the reflector body Remove the lamp protection paper
4. Push the protection back into the slide and attached the end covers
Filter replacement
8.3
Note! The filters are disposable and should not be reused.
1. Use a screw driver to open the filter box.
2. Remove the used filter.
3. Insert the new filter.
4. Close the filter box.
