Page of 8
4
CHART FOR MINIMUM WIRE SIZE OF EXTENSION CORD:
Nameplate AMPS
CORD LENGTH
25’
50’
100’
150’
0-6
18 AWG
16 AWG
16 AWG
14 AWG
6-10
18 AWG
16 AWG
14 AWG
12 AWG
10-12
16 AWG
16 AWG
14 AWG
12 AWG
12-16
14 AWG
12 AWG
(NOT RECOMMENDED)
If in doubt, use larger cord.
Be sure to check voltage requirements of the tool to your incoming power source.
•
Do not expose
power tools to rain or wet conditions. Water entering a power tool will increase
the risk of electric shock.
•
Do not let your fingers
touch the terminals of plug when installing to or removing from the
outlet.
•
Ground fault circuit interrupters.
If work area is not equipped with a permanently installed
Ground Fault Circuit Interrupter outlet (GFCI), use a plug-in GFCI between power tool or
extension cord and power receptacle.
PERSONAL SAFETY
•
Stay alert,
watch what you are doing and use common sense when operating a power tool. Do
not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A
moment of inattention while operating power tools may result in serious personal injury.
•
Dress properly.
Do not wear loose clothing, dangling objects, or jewelry. Keep your hair,
clothing and gloves away from moving parts. Loose clothes, jewelry or long hair can be caught
in moving parts. Air vents often cover moving parts and should be avoided.
•
Use safety apparel and equipment.
Use safety goggles or safety glasses with side shields
which comply with current national standards, or when needed, a face shield. Use as dust mask
in dusty work conditions. This applies to all persons in the work area. Also use non-skid safety
shoes, hardhat, gloves, dust collection systems, and hearing protection when appropriate.
•
Do not overreach.
Keep proper footing and balance at all times.
•
Remove adjusting keys or wrenches
before connecting to the power supply or turning on the
tool. A wrench or key that is left attached to a rotating part of the tool may result in personal
injury.
BENCH TOP BUFFER USE AND CARE
•
Always check for damaged or worn out parts before using the Bench Top Buffer.
Broken
parts will affect the Bench Top Buffer operation. Replace or repair damaged or worn parts
immediately.
•
Do not force the tool.
Tools do a better and safer job when used in the manner for which they
are designed. Plan your work, and use the correct tool for the job.
•
Never use a tool
with a malfunctioning switch.
Any power tool that cannot be controlled with the
switch is dangerous and must be repaired by an authorized service representative before using.
•
Disconnect power
from tool
and place the switch in the locked or off position before servicing,
adjusting, installing accessories or attachments, or storing. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
•
Secure work
with clamps or a vise instead of your hand to hold work when practical. This
safety precaution allows for proper tool operation using both hands.