15
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
4. Place one washer on each stud. Using a 3/8” nut driver, snug up the
nuts on each piece of trim. Do not finish tightening the nuts yet. See
Figure 19.
5. There should be approximately a 7/8” (22 mm) gap between the top
edge of the upper door trim and the top edge of the front door and
a 1-1/2” (38 mm) gap between the lower door trim to the bottom of
the front door. Visually inspect the alignment of the trim and adjust
if necessary. See Figure 20.
6. Finish tightening nuts. CAUTION - DO NOT OVER-TIGHTEN NUTS,
DIMPLING OF THE TRIM WILL OCCUR!!!
Trim stud
Door Handle
Holes for trim studs
Top edge of lower door trim
Figure 16
Figure 18
Figure 17
Figure 19
Figure 20
Bottom edge of lower door trim
to bottom edge of front door
1-1/2”
9/16”