STEP SEVEN:
Locate the following parts and hardware. 1x LOWER PULLEY BAR, 1x PULLEY,
1x M12x45mm bolt/1xM12 washer/1x nylock nut, 2x Plastic Caps/2x M8 x 25mm bolts/2x FOAM
PADS/2x BALL PINS
LOW PULLEY BAR
FOAM PAD
PULLEY
BALL PIN
Nylock nut
M12x45mm bolt
PLASTIC END CAP
Washer (M12)
Install PULLEY onto LOW PULLEY BAR with
M12x45mm bolt/nylock nut and M12 washer
Slide FOAM PAD onto LOW PULLEY
BAR and secure with Plastic Cap M8
Washer and M8x25mm bolt
Install LOW PULLEY BAR onto MAINFRAME on left side as
shown. Align BALL PIN through MAINFRAME Pin bracket and
then Through LOW PULLEY BAR. NOTE: Make sure the LOW
PULLEY BAR is mounted as shown, so that LOW PULLEY BAR
can pivot into the MAINFRAME or be locked into place as shown
below on right side with other BALL PIN prior to use
BALL PIN
M8 x 25mm bolt
Washer (M8)
