Carabineer
LAT PULL BAR
To set up the LOW PULLEY BAR for use, first swing the Low Pul-
ley bar into position and secure with BALL PIN. Next, attach LOW
PULLEY CABLE to ball end of upper pulley by first threading eye-
let end up through the LOW PULLEY BAR pulley and then secur-
ing with Carabineer.
Then, attach the LAT PULL BAR to the LOW PULLEY CABLE
using a Carabineer. Make sure the J-hook is properly seated un-
der the LIFT BAR and that the Safety hooks on LIFTING BAR are
located in upper position with lock out bolt in place prior to use.
J-Hook
BALL PIN
LOW PULLEY CABLE
Carabineer
When not in use, the LOW
PULLEY BAR swings into the
frame as shown. Leave the
BALL PIN in the mainframe to
avoid loss.
When not in use, you can use
the J-hook on the rear of the
mainframe SPINE for storage
as shown below.
LOW PULLEY CABLE
