STEP FIVE:
Locate the following parts and hardware. 4x PLATE HOLDERS/8x STAND OFF plas-
tic spacers/1x J-HOOK /4x M10x 40mm bolts and 4x M10 washers.
First, slide the 4x PLATE HOLDERS into the
SPINE.
Next, Install the M10x40mm bolts/M10 washers
through the
bottom three holes
located in the
rear of the SPINE and secure the PLATE HOLD-
ERS into position. Tighten.
Then, slide the 8x STAND OFF plastic spacers
onto the PLATE HOLDERS.
Next, locate the J-hook (shown below) and install,
through the
uppermost hole
in SPINE, the
M10x40mm bolt, M10 washer and the J-hook as
shown.
STAND OFF plastic
spacer
J-HOOK
PLATE HOLDER
STAND OFF plastic
spacer
