13
Step 5
Attach the top end of Handlebar (29) onto the Rear
U-Frame (2) and Pivot Arm Ring (72) with one M8x23
Hex Head Bolt (38), M8 Lock Nut (15), and two
Ø20xØ8.5x1.5 Washers (13). Attach the bottom end of
the Handlebar (29) onto the Rear U-Frame (2) with one
M8x43 Hex Head Bolt (43), M8 Lock Nut (15), and two
Ø20xØ8.5x1.5 Washers (13). Tighten bolts with two
Multi Hex Tools provided. Install two Ø27xØ13.5 Nut
Caps (55) onto M8x23 Hex Head Bolt (38).
Repeat above same steps to attach the other Handlebar
(29) onto the Rear U-Frame (2) and Pivot Arm Ring (72).
Hardware:
․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․
Step 6
Pull out the Spring Knob (18), and slide the Adjustable
Boom (3) into the square bracket on the bottom of the
Bed Frame (4) as shown. Slide the boom upward, until
the desired height on the Height Scale (44) is just below
the bracket on the bed frame. Lock the Adjustable
Boom (3) in place by releasing the Spring Knob (18) and
sliding the Adjustable Boom (3) up or down slightly until
the Spring Knob (18) "pops" down into the locked
position. For added safety, secure the Knob (30) into
the back side of the bracket on the Bed Frame (4) as
shown.
13
15
29
43
13
13
15
3813
2
72
55
Multi Hex Tool with Phillips Screwdriver
Tool:
Hex Tool
4
3
30
18
44
2 Hex Head Bolts
(M8x23)
2 Hex Head Bolts
(M8x43)
8 Washers
(Ø20xØ8.5x1.5)
4 Lock Nuts (M8)
2 Nut Caps (Ø27xØ13.5)
Summary of Contents for 5214
Page 5: ...4 WARNING LABEL PLACEMENT ...