ZProxy Server (available at zproxy.con.ru) allows the (proxied) connection between controller
and the control software, where direct connection is impossible, e.g. if the controller and the
software are in different LANs. If Internet access is available, 1) the controller connects to ZProxy
server, 2) the control software connects to that server too, and 3) using a password, the control
software requests connection to the required controller.
If no connection exists to control software, the controller will work in
Standalone
mode.
To configure controller functioning mode, use a jumper on the PCB, which can be set as follows:
·
CONFIG
: on power-up, the controller boots into setup mode, to configure connection
parameters and equipment types.
·
NORMAL
: Normal mode – the connection module connects to LAN as configured, the
controller makes access control decisions. The existing connection parameters and connected
equipment can be configured at a local IP address.
·
LOCK
: same operation as at NORMAL. However, both the Web interface for connection
parameters and connected equipment configuration, and data update in Web connection mode, are
locked.
5. WEB INTERFACE
The Web interface is used to configure connection parameters and connected equipment.
You will require a device with a Wi-Fi network connection (smartphone, tablet or notebook),
and an Internet browser (Internet Explorer, FireFox, Opera, Chrome etc.)
Launch the Web interface for controller configuration, via the following sequence:
1. Set on-board jumper into CONFIG position.
2.
Power up the controller.
Zproxy
Z-5R
WEB
Internet
>LOCK
>NORMAL
>CONFIG
Z-5R Web
www.ironlogic.
me
page
8
