Putting on the iReliev
®
Conductive Back Wrap
1. Before putting on the Conductive Back Wrap, remove any residue on skin, cream or oint-
ment. Make sure that your skin is clean. Do not place the wrap on injured or inflamed areas of
the skin, such as wounds, sores, rashes or reddening.
2. Before use, apply iReliev
®
Conductive Gel. Or you may dampen the integrated silicone elec-
trodes with water but use extreme caution to not oversaturate.
3. Position the Conductive Back Wrap so that the electrode pads are on the area of the body
to be treated. If your lower back aches at waist level, position the wrap so that the middle of
the wrap sits approximately 1 to 2 inches below the waist. The Wrap should fit very snugly
around your body as follows:
4. When the wrap has been placed in the correct position, bring the two ends of the neo-
prene straps together and fasten with the built-in hook and loop closure so that it is snug.
5. The wrap may be tightened or loosened as shown by adjusting the hook and loop closure.
(See diagram below)
▲
NOTE/CAUTION: Subjective perception of the electric current may alter with changing fre-
quencies or pulse widths. Lower the intensity as soon as the application becomes unpleas-
ant or the pleasant prickling sensation is not felt for a long period of time.
Please ensure that iReliev
®
Conductive Gel has been applied over the silicone pads to allow
for optimal conductive impulse dispersion. If this step is not completed, impulse sensation
may feel like a prickling sensation and may be uncomfortable.
9
