iQ360XT
Operator’s Manual
888-274-7744
www.iqpowertools.com
UNPACKING, TRANSPORT & ASSEMBLY
Unpacking
Your iQ360XT® has been shipped from the factory
thoroughly inspected. Only minimal assembly is required.
If not already done, remove the iQ360XT® from the
carton and place saw on top of Dust Tub and fasten.
Check contents with list below.
Transport
The iQ360XT® weighs approximately sixty-five pounds
making transport easy.
Always observe safe lifting practices when
lifting the iQ360XT®.
NOTE: Lock the Cutting Head in the DOWN position
The iQ360XT® is designed to be carried by the handles
at the front & back of the saw. Simply lock (1) the spring
assisted Cutting Head in position (2), grasp the lower
front and rear cross members (3,4). Lift and handle the
iQ360XT® to the desired location.
Setup
Before powering or starting, check for damage that
could prevent this equipment from proper operation or
performing its intended function. Check for binding and
alignment of moving parts. Check for damaged, broken,
or missing parts.
• Before connecting the iQ360XT® to a power supply, be
sure the voltage, cycle and phase of the job site power
source meet the requirements listed in Technical Data.
• If using an extension cord, make sure the length
and wire gauge corresponds to the requirements
listed in Technical Data. An extension power cord that
is too small in wire gauge (diameter), or too long in
length, will cause the motor to overheat and could
cause premature failure.
• Do not cover the motor vents as this could lead to motor
overheating.
4.1
CONTENTS:
ITEM #
QTY
DESCRIPTION
1
1
iQ360XT
2
1
Dust Tub
3
1
Filter
4
1
Owner’s Manual
5
1
Warranty Card
