IQCCTV
IQ960DVR User Manual
39
5.3.6 Advanced
5.3.6.1 Motion
Click the [Main menu
à
Alarm
à
Motion] to enter into the interface as shown below.
Ø
Channel:
Enable/disable the motion function for any channel.
Ø
Area:
Click the [Setup] button to enter into area setup interface.
Ø
Sensitivity:
Set sensitivity level of motion detection from high to low. Sensitivity ranges from
1-8 with 8 being the most sensitive.
Ø
Alarm out:
Connect external alarm sensor.
Ø
Latch time:
Set how long the buzzer will sound when a moving object is detected (10s, 30s,
40s, 60s).
Ø
Show Message:
Change the message that displays on the screen when the motion alarm is
detected.
Ø
Buzzer time:
Set how long the buzzer will sound when motion is detected (off, 10s, 30s, 40s,
60s);
Ø
Send Email
：
Choose whether to send images to a specified email when the alarm is
triggered.
Ø
Full screen Alarm:
The function is defaulted to “On". When motion is detected, the
corresponding channel will be switched to the full screen mode.
Ø
Record Channel:
The record channel will be activated when a moving object is detected.
Ø
Post Recording:
Set how long the alarm record will last after the alarm ends (30s, 1minutes
，
2minutes
，
5minutes).
Ø
Copy:
Copy current channel parameters to any other channel or all channels.
The channel will be separated into 44x36 grids (PAL/NTSC mode). When an object moves into
the motion detection area and the area where the object is located is displayed in red, then
motion detection will be triggered. In the semi-transparent area, the motion detection is not
activated. After configuring the above parameters, click <OK> to save it.
