IPN W9 Series, Operation Manual

Page: 12 / 22

12
•
Ensure that the 'Bluetooth' button on top of the headset base is selected.
3.1.4 Making or receiving a Bluetooth call
•
Make or answer the call on your bluetooth device ensuring that the DECT Headset is
selected as your audio device
3.2 Adjusting the Ringing Volume
When the headset is ringing to indicated an incoming call, you can adjust the ring volume
using the volume control buttons located on the headset.
•
Lift the headset from the base or press the headset's ON/OFF button if you are already
wearing it and the base 'On line indicator’ LED will light.
3.3 Muting The Headset Microphone
To mute the headset microphone when on a call, press the 'Mute' button on the headset.
While the headset is in Mute mode, a short beep will be heard on the headset every 8 seconds.
Press the 'Mute' button again to release the mute.
•
After finishing your call, press the ON/OFF button on the headset or end call button on the
bluetooth device to disconnect. The base ‘Online indicator’ LED will turn off.
Use the volume control buttons on the headset to adjust the receive volume on your headset.
You will hear a beep sound for each volume step Up or Down.
3.4 Headset transmitting volume setting
You will hear a warning tone in the headset when you walk out of range of the base. The
You can adjust the transmit volume of the headset by using the two buttons located on the
bottom of the headset base.
3.5 Adjusting Headset Receive Volume
3.6 Out of range and reconnection