IPG RSA 2024-SB, Operations Manual & Parts List

Page: 40 / 117

UM122TW / UM622TW UDM10012
40
O
PERATING
I
NSTRUCTIONS
4. Speed of Raising of Top Tape Head Box
If the Top Tape Head box slams when it reaches its apex or ascends to quickly the flow controls
at the top of the side cylinders need to be adjusted (
Figure-31 ). Using a flat head screwdriver,
turn clockwise to slow the ascent and counter-clockwise for a faster ascent. Both cylinders
should be adjusted the same amount and should be done 1/8 of a turn at the time.
5. Drive Base Adjustment
Speed of closing and opening:
The Flow Control Valves at each end of the drive base cylinder under the machine controls the
speed of closing and opening of the drive base. Using a flathead screwdriver, turn clockwise to
slow the movement of the drive bases and counter-clockwise for a faster movement. This
adjustment is to be done 1/8 of a turn at a time. The flow controls regulate the flow of the air
exiting the cylinder.
For Heavy cases:
If drive bases do not close completely to power the case during processing, increase air
pressure on the “Drive Base – Closed” regulator (
Refer to Page 29 ). The air pressure should be
increased by 5 PSI at a time by turning the knob clockwise until the box can be centered by the
drive bases. Different types of boxes may require slightly different adjustments than those that
are factory-preset.
For fragile cases:
To prevent the drive bases from closing too quickly and too hard on fragile boxes, the air
pressure regulator and flow controls can be adjusted as necessary.
Figure-31
Flow Control
Adjustment Flow Control
Adjustment