Universal WiFi BAT Installation Guide (rev 1.0) 12
Troubleshooting Diagnostic Information
Under normal operation the Activity light will periodically blink. A
power cycle is recommended if the Activity light is not periodically
blinking.
LED
– 1
is used for DHCP & Network connection diagnostics:
Solid:
Indicates a connection has been made to ipDatatel.
(The unit is Online)
3 Flashes:
Indicates the device is not connected to the Internet
or is not pulling a DHCP from the router.
7 Flashes:
Indicates the device is still working on “AP
Configuration”, therefore is not connected to a WIFI Network.
LED
– 2
is used to indicate Key Bus Connectivity.
LED
– 6
Flashing:
Indicating it’s searching for a router in WPS Mode.
Solid:
Indicates it found a router via WPS Mode.
LEDs
– 3 to 6
are used for WIFI Signal Strength, which is updated
on Startup and once every 4 hours.
Validating the Installation
After the unit is properly connected to the Alarm Panel and
powered up, use the following steps to validate that the system is
functioning properly:
Ensure that virtual keypad functionality works through
www.alarmdealer.com, or the SecureSmart mobile app.
Ensure that alarm signals reach your central station.
Wiring & Programming for Popular Panels
The following pages are organized by Alarm Panel type. Wiring
and programming instructions are given for:
Digital Security Control (DSC) Alarm Panels
Honeywell Vista Alarm Panels
GE NetworX Alarm Panels
