Universal WiFi BAT Installation Guide (rev 1.0) 10
Log in to www.alarmdealer.com with the dealer login information
that was emailed to you.
Navigate to ‘Dealer Menu’->’Hardware Registration’
Enter the MAC address for the board you wish to register
Adding BAT to a Customer Account
After registering the hardware, the BAT-WIFI must be added to a
Customer Account by following these steps:
Log in to alarmdealer.com with the dealer login information that
was emailed to you.
Navigate to ‘Dealer Menu’->’User Accounts’, then click ‘Create
Account’
Fill in the customer information
Click ‘Add Hardware’
Find and select the BAT-WIFI you registered earlier. You can
search for it by MAC address.
Follow other registration steps and options as found on this
page, then click ‘Save’ to complete the registration.
Locating and Installing the BAT-WIFI
The BAT-WIFI connects to the
alarm panel’s power connections,
Telco, virtual keypad bus (if available), and key switch connections
(optional).
The BAT-WIFI should be connected to the Internet via a hard-
wired (RJ45) internet connection located on the lower-right hand
side to the circuit board. If a hard-wired Internet connection is not
available then the (WIFI) connection will be used. The BAT-WIFI
automatically seeks an IP address. There is no need to program
routers or switches.
Telco - Digital Dialer
The BAT-WIFI
’s signal collection expects Contact ID format from
the digital dialer on the alarm panel. Most control panels made in
the last decade are CID capable. Wire the Telco side of the alarm
control's Tip & Ring to the BAT-WIFI Tip & Ring.
Virtual Keypad Connection
The BAT-WIFI connects to most panels as a Virtual Keypad,
allowing the customer full virtual keypad access after they
authenticate using the customer username and password you
have assigned them in the pre-installation phase. This allows the
customer to use the SecureSmart mobile phone and web
interfaces. You will need to refer to the wiring diagram for your
