Universal WiFi BAT Installation Guide (rev 1.0) 11
specific panel because the panel side the Virtual Keypad
connection has various labels (Data in-Data out, YEL-GRN, or just
Data). This connects to the G/RX, Y/TX connections on the BAT-
WIFI.
Power Connection
The last step is to w
ire the alarm panel’s 12VDC auxiliary power
and ground to BAT-WIFI positive (pin 3) and negative (pin 4)
terminals. See Wiring Diagram on page 30.
Basic Programming
Because the BAT-WIFI simulates telephone service to the panel,
general programming for the control is limited to configuring the
signal format as Contact ID, as well as inputting a telephone
number to dial. In this case the actual telephone number does
NOT matter and is NOT used in the signal delivery process.
Full Virtual Keypad Programming
For pane
ls that are “Interactive Ready” (See Supported Panels
section page 25) the following programming will give you full virtual
keypad access to where the customer can enter their 4 digit code
to arm & disarm the system, when using SecureSmart mobile and
web interfaces.
DSC Panels: No programming required to make the virtual keypad
operate.
Vista Panels: Enable *193 with (1,0) to turn on Address 20.
