IPC Eagle BB20N, Operation Manual

Page: 7 / 40

7
This machine is manufactured for commercial use only.
This machine is designed and manufactured for burnishing indoor hard floor surfaces. IPC Eagle does
not recommend use of this machine in any environment other than an indoor environment.
Battery powered floor equipment is designed and manufactured for commercial use only. These
machines are designed to burnish most modern types of floors including composition tile, stone, marble,
terrazzo, and resilient floor covering, and some coated wood floors.
Operator Responsibility
The operator is responsible for performing the recommended daily maintenance and checkups of the
machine to keep it in good working condition. The operator must inform the service mechanic or
supervisor when recommended maintenance procedures are required
as prescribed in the MAINTENANCE section of this manual. Read this manual carefully before operating
this machine.
FOR SAFETY: Do not operate machine before reading and understanding the operation manual.
Check the machine for shipping damage.
Keep your machine regularly maintained by following the maintenance information in this manual. We
recommend taking advantage of a service contract from your IPC Eagle Distributor or Service Center.
Order parts and supplies only from an Authorized IPC Eagle Distributor. Use the parts illustration
section of your manual when ordering parts.
During and after operation, perform the recommended daily and hourly procedures outlined in the
Maintenance Chart.
Machine Preparation
Unpacking the Machine
1. Cut and remove green bands holding the box to the pallet.
2. Remove staples attaching the box to the platform at the edge of the box.
3. With two people, one at either end of the box, lift box straight up and off the machine.
4. Remove loose accessories from the top of machine.
5. Cut and remove the bands across the top of the machine and across the burnish head.
6. If the machine has batteries, then remove the battery cover and plug the battery pack plug into
the machine, turn on the key, drive the machine down the ramp off the pallet. If the machine does
not have batteries, pull the machine down the ramp and off the pallet. See the "Connecting the
batteries" section of the manual.