Page 5 of 16
Drawing : - TPC572
Issue
: - 1
Date
: - 08/02/22
SYSTEM INSALLATION
WIRING
Connect a suitably fused 220V 60Hz 3 phase mains power supply to the
MAINS T/B terminal block inside the electrical box located at the control panel
end of the machine.
DRAINAGE
Connect the outlet from the drain tray (located behind the front grille and
under the evaporator coils) to a suitably sized hose and run the hose to a
permanent drain.
Please ensure that the drainage does not rise above the level of the CD425’s
drain tray. Failure to observe this requirement will result in internal flooding of
the dehumidifier.
POSITIONING
The CD425 is designed for indoor use only.
Position the dehumidifier unit in the centre of the room to be conditioned if at
all possible. Using a spirit level ensure the unit is level in both directions.
Failure to do so may result in the drain tray overflowing and flooding of the
chamber.
NOTE: Both inlet grille and outlet grille of the dehumidifier unit must have
clear space around them and not be obstructed in anyway.
Minimum installation requirements.
A gap of at least 1000mm is required above the dehumidifier.
AIR IN
AIR IN
AIR OUT
400mm
400mm
250mm
250mm
