Designation: AIR CONDITIONER FOR ELECTRICAL ENCLOSURE
Page 8/20
UMA-CDZ-IP-ACIRM100-00
3.2 ELECTRICAL INSTALLATION
The electrical installation must be carried out by a qualified electrician who
is responsible for compliance with the applicable standards and
regulations.
Upstream of the electrical connection, a power line disconnector must be
provided in compliance with the
AS / NSZ 3000 standard
Before the installation make sure that the cabinet is disconnected from the
electrical supply.
Wire male plug (included) with an adequate cable as is shown by following picture
Cable section must be at least 1,5mm
2
The male plug is fitted with spring terminals:
1) Push the spring with a screwdriver and then insert
the wire.
2) Check the proper wire insertion.
3) Insert male connector inside of 3 poles female
connector placed on the bottom of the air
conditioner.
When the air conditioner is installed on electrical enclosure,
female connector is accessible only from inside the enclosure.
