Wireless N150 Long Range AP/Router
79
Appendix 3 FAQs
This section provides solutions to problems that may occur during installation
and operation of the device. Read the following if you are running into
problems. If your problem is not covered here, please go to our website of
www.ip-com.com.cn or e-mail to [email protected] for help.
1. Q: I entered the device’s LAN IP address in th
e web browser but
cannot access the utility. What should I do?
A: 1) Verify physical connectivity by checking whether a corresponding port’s
link LED lights up. If not, try a different cable. Note that an illuminated
light does NOT ALWAYS indicate successful connectivity.
2) In
Router Mode
, you must use a wireless network adapter to connect
to the device, as the
LAN/WAN
Ethernet port works as a
WAN
port for
Internet connection; while in
AP Mode
,
Universal Repeater Mode
, you
must specify an IP address (192.168.2.2~192.168.2.253) on your PC to
connect to the device. 3) Click
Start
-->
Run
, enter
cmd
and then input
ping 192.168.2.1
to check the connectivity status between your PC and
device. If ping succeeds, then check whether the Proxy Server feature is
enabled on your browser. If enabled, disable it immediately. In case that
ping fails, press and hold the "RESET" button on your device for 7 seconds
to restore factory default settings, and then run “ping192.168.2.1” again.
Contact our technical support for help if the problem still exists after you
tried all the above.
2. Q: What should I do if I forget the login password to my device?
A: Reset your device by pressing the Reset button on the PoE injector for
8~10 seconds. Note: All settings will be deleted and restored to factory
defaults once you pressed the Reset button.
3. Q: My computer shows an IP address conflict error after having
connected to the device. What should I do?
A: 1) Check if there are other DHCP servers present in your LAN. If there are
other DHCP servers except your router, disable them immediately.
2) The default IP address of the device is 192.168.2.1; make sure this
Summary of Contents for P115AP
