
8
●
Dolby Upmix
The source signal is converted into 3D sound using the Dolby Upmix algorithm. Equalizers are active if
desired. The distance and volume settings of the individual channels are active.
●
DTS Neural: X
The source signal is converted into 3D sound by the DTS Neural: X algorithm. Equalizers are active if
desired. The distance and volume settings of the individual channels are active.
●
Remember
Here you can choose whether the selected playback mode is saved and should be stored after the
device is restarted.
PARAMETERS
Here you can make short-term volume settings for each speaker and adjust the lip synchronization. These
settings are not saved and are no longer saved after restarting the device.
ZONE 2
Here you can make settings for playback in Zone 2:
●
Enable
Here you can activate playback via the Zone 2 output on the back.
●
Source
Here you can select the desired source that is to be output via Zone 2.
●
Volume
Here you can select the desired volume for zone 2.
SETUP
Here you configure your system and make basic settings:
Source setup
Here you can configure the sources. The following options are available:
●
Enable - Here you can activate or deactivate the source.
●
Rename - Here you can rename the source.
●
Video source - Here you can select a different video source.
●
Audio source - Here you can select a different audio source.
●
EQ select - Here you can select the desired equalizer preset.
●
Volume mode - Here you can set the volume of the source individually.
●
Trigger out - Here you can set whether a trigger signal is output when the source is selected.
●
Default - Here you can reset all selected settings of the source.
Audio mode
Here you can assign individual playback modes for all source signals so that the assigned playback mode is
automatically selected when a certain source signal is present.
8