SIGLINK
–
TEMP HUM DG1002 Quick Start Guide
Version 1.0
Page 4 of 6
This option is mainly for developers who want to make their own integration. The data on the Sigfox
backend will be shown in raw format. How to decode them is described in our document DG1001
(Device operation and message format).
3.3
Other platforms
There are multiple other platforms which can be used for device integration. Some of them provide
Sigfox connectivity as well as interface for data visualization, others provide only the data visualization
(without the Sigfox connectivity).
Check available platforms at our web page:
https://www.iot-gsolutions.com/en/siglink-en
4
Powering the SIGLINK sensor
After you gained the Sigfox connectivity (see section 3), the SIGLINK can be switched ON by pulling out
the activation strip.
Upon activation, the measured data are immediately sent out and visualized on the portal/platform you
have registered the device on.
5
SIGLINK installation
To get the best signal performance out of the SIGLINK sensor, the installation should follow the
recommendations below:
•
Installation position is
vertical
(standing).
•
The device is not behind thick walls, in deep cellars or at any places which could cause high
signal attenuation.
•
Water could damage the sensor. The device should not be exposed to direct rain or snow.
6
Troubleshooting
6.1
How can I get the data out of the device?
Please see the section 3 in this guide. You have to get the Sigfox connectivity for your sensor. It can be
done through our IoTpool platform, directly through Sigfox or through any other third-party platform.
