Page
9
of
18
Install the BoxDim Scanner Device
WARNING:
A tall stool or ladder is required for the following steps if the scanner is installed on a
countertop or a wall that is beyond reach when standing on the floor. Get assistance from another
person and follow all safety instructions for the stool or ladder.
1.
Choose
the
I
nstallation Holes:
a.
Choosing the installation holes to mount the scanner to the scanner pole requires
finding a hole that is roughly above the center of the scale. There are seven (7)
mounting holes
b.
Hold the included cloth ruler so that one end hangs from the scanner pole and the far
end is roughly over the center of the scale.
c.
Choose a hole that is closest to the end of the ruler at the scanner pole end of the tape.
This is the front mounting hole for the scanner.
d.
Make sure that another hole is available 3 inches behind that hole (closer to the upright
pole or wall) which is the rear scanner mounting hole. If there is not one there, choose
the next hole forward.
2.
Mount the Scanner:
IMPORTANT:
Keep the bottom scanning surface covered with the foam packaging until
is it mounted on the scanner pole.
a.
Hold the BoxDim scanner so that the back of the unit with all the connection openings
and labels faces the stand upright pole/wall
AND
the foam‐covered scanning surface
with the LEDs and holes faces down.
b.
Insert both #10‐32 screws through the holes in the scanner pole chosen above and into
the threaded holes on the top of the scanner.
c.
Tighten the screws with a Phillips screwdriver so that scanner remains in place. Do not
overtighten.
d.
Remove the protective foam sheet from the bottom of the scanner.
