Page
8
of
18
b.
Insert the plastic cap into the exposed top end of the upright pole using a hammer to
lightly tap into place. Insert a piece of cardboard or wood over the cap to prevent
damage to the cap.
6.
Install the Scanner Pole:
WARNING:
A tall stool or ladder is required for the following steps if the scanner is
installed on a countertop or a wall that is beyond reach when standing on the floor. Get
assistance for another person and follow all safety instructions for the stool or ladder.
a.
Place the scanner pole within reach.
b.
If counter mounting,
make sure the scanner pole clamp pieces are interlocked together
on the side opposite the Allen screw.
c.
If counter mounting,
loosen the Allen screw until it is just about to fall out. Slide the
scanner pole clamp over the upright pole and hold it in place with one hand.
d.
If counter mounting,
while holding the scanner pole clamp in place,
fully
insert the end
of the scanner pole
without drilled holes
into the scanner pole clamp and lightly tighten
the Allen screw so that pole remains in place.
e.
If wall mounting,
insert the scanner pole into the stand base and lightly tighten the set
screw.
The stand base is NOT mounted to the wall yet.
f.
Rotate the scanner pole so that the drilled holes face upwards.
g.
The scanner pole requires adjustment later so do not snugly tighten yet.
CLAMP
NOT
INTERLOCKED
CORRECTLY
CLAMP
INTERLOCKED
CORRECTLY
