16
Part 4. Functions and operation:
4.1 Housing Back:
1.
POWER IN:
IEC current input socket with fuse holder for F10AL230V fuse..
The assignment of the connection leads is as follows:
Wire
Pin
International
Brown
Outer conductor
L
Blue
Neutral conductor
N
Yellow/Green
Earth conductor
The earth conductor must be connected!
IMPORTANT NOTE:
Replace the fuse only with a fuse of the same type and with the same values (imprint on the
device). If the fuse is triggered repeatedly, please contact an authorized service center.
2. Hand release button:
Used for manual triggering of the fog
.
3. Power switch:
ON:
Indicates the power is on. OFF: Indicates that the unit is switched off. The mains switch
switches off unipolar, so the mains plug must be disconnected before the housing is opened to avoid electric
shock.
4.
DMX Out:
3-pin female XLR connector for forwarding the DMX control signal
5.
DMX IN:
3-pin male XLR connector for connecting a DMX control device (e.g., DMX mixer).
6.
On-Board Menue:
Displays the operating mode and the value of individual functions.
7. 5-pin remote control input:
This input is used to connect the remote control unit (W-2), cable remote
control unit (X-2) or the timer controller (D-800)
.
Note:
Disconnect the power cord from the power source before removing or replacing the remote control.
1.
2.
3.
4.
5.
6.
7.