15
Part 2. Intended use:
This information sheet contains important information on the safe operation of the device. Ensure that this
information is available to all persons using this device.
Type plate is located on the bottom of the unit.
This device is designed to create artificial mist by evaporation of the nebulised fluid and is intended for
professional use only.
This product is not intended to be used in residential areas. This product is dangerous for
electric shocks, burns, crashes and personal injury! This product is only approved for connection to AC220-230V,
50Hz alternating voltage and has been designed for indoor use only. Only use the fog machine as described in the
supplied operating instructions. When choosing an installation location, make sure that the unit is not exposed to
excessive heat, moisture, or dust. Make sure there are no cables around. You endanger your own and the safety of
third parties! Make sure that there is always a sufficient amount of mist fluid in the tank. Operation without mist fluid
results in pump damage and overheating of the heating element. Do not operate the unit until after you have
familiarized yourself with its functions. Do not allow the appliance to be used by persons who are not familiar with
the appliance. If the device is to be transported, always empty the tank and use the original packaging in order to
avoid transport damage.
The device may only be used by persons who have adequate physical, sensory and mental abilities as well as
appropriate knowledge and experience. Other persons may only use the appliance if they are supervised or
directed by a person responsible for their safety.
A mist machine can only work safely with the INVOLIGHT mist fluid developed for the machine. Only use fluid that is specified
in the "Matching accessories" section on the last page. Doing so may result in toxic, harmful gases or damage to the unit. Do
not expose the fog to persons with allergies or respiratory diseases (asthma). Do not create a dense fog in closed or poorly
ventilated rooms.
This unit ejects hot steam. Never aim a fog machine at people or their clothes
!
Any other use or use under other operating conditions is considered to be improper and can lead to personal injury
or property damage. No liability is assumed for damages resulting from non-intended use.
Part 3. Commissioning:
Place the unit on a flat, dry surface. Fill the tank with INVOLIGHT fog liquid. All other types of fluid may cause
damage to the unit.
After filling, close the tank with the lid. Plug the remote control cable firmly into the correct input jack on the back of
the unit. Connect the device to an appropriate power supply. Switch the machine on with the mains switch on the
back (position 'ON'). Wait about 3 minutes for the unit to reach operating temperature. When the machine is
finished with heating the display shows "READ". The device is now ready for use. To release the fog, press the
corresponding button on the remote control or the manual button on the back of the unit.
The unit must never be operated unattended!
Should any liquid fall into the interior of the unit, immediately disconnect the mains plug and consult a specialist.
Your model has a hanger. The unit can be installed on the floor or hanging.
DANGER: Equipment installed overhead can cause serious injuries when you fall over! If you are in doubt
about the security of a possible installation, DO NOT install the device!
IMPORTANT!
Overhead mounting requires a high degree of experience. This includes knowledge of the load-
bearing capacity, the installation material used and the safety inspections of the material and the projector used,
but the required experience is not limited to this alone. Under no circumstances should you try to perform the
installation yourself if you do not have the appropriate qualification. Instead, commission a professional installer.
Incorrect installation may result in personal injury and / or damage to property.
During installation, the provisions of BGV C1 (formerly VBG 70) and DIN 15560 have to be observed! The
installation may only be carried out by authorized specialists!