20
21
INSTALLATION
INSTALLATION
20
21
sMove controller | Installation instructions
sMove controller | Installation instructions
5.4 Installing the operating unit
The control unit is mounted on the prepared controller mounting box. The fan cables are in the
box and are already distributed in it. Depending on the installation scenario, the switching power
supply is located in the control cabinet or in the lower area of the mounting box.
To connect an optional sensor, e.g. CO
2
sensor or to a home automation system, follow the
instructions in grey italics.
Stripping tool; crimping pliers; screwdriver
Requirements:
• The switching power supply unit is attached.
• The fan wires are distributed.
►
Pull the lever on the lower right side of the operat-
ing unit backwards (1).
►
Slide the base plate downwards as far as the stop
(2).
The operating unit is unlocked.
►
Remove the base plate from the operating
unit (3).
The base plate has been removed from the
operating unit.
►
Screw the operating unit base plate to the box
using fixing screws.
The arrow above the lettering TOP is
pointing upwards.
!
NOTICE: If
the terminals are connected
incorrectly, the sMove controller or connected
components will not work!
• Ensure the correct terminal assignment
when connecting the cables.
►
Attach the cables to the back of the operating unit:
• Operating voltage cable
, 2-core, in the two
upper poles of the 5-pole connection terminal:
- Red wire (+) to the first connecting pole
- Black wire (
┴
) to the second connecting pole;
• Fan BUS
, 3-wire, in the three lower poles of the
connection terminal;
- DIR1 (III) in the third connection pole
- VOUT+
(IV
) in the fourth connection pole
- DIR2 (V) in the fifth (lower) connection pole;
• Optional:
Sensor cable
, 2-wire, to the 2-pole
connection terminal.
Termi
-
nal
Meaning
Colour
+ 24 V
Supply voltage
24 V DC
Red
┴
GND
Black
DIR1
Direction signal 1
White
VOUT+ Fan operating voltage
Green
DIR2
Direction signal 2
Brown
SC1 (+) External interface
(optional sensor)
SC2 (–)
1
2
3
1
2
3
+ 24 V
–
DIR1
VOUT+
DIR2
SC1
SC2
