INVENTOR ATM-25L, User Manual

Page: 23 / 200

23
EN
The unit does not start
l
Make sure the dehumidifier’s plug is placed completely into the socket.
l
Check the house fuse/circuit breaker box.
l
Check whether the power cord is damaged.
l
Check the water bucket, if it is full, empty it.
l
Check if the dehumidifier has reached its preset level.
l
Make sure the water bucket is positioned properly.
l
Room temperature is lower or higher than the advised operational range.
l
Check whether the humidity level has been set in high levels.
Dehumidifier does not dry the air as efficient
l
Make sure that the dehumidifier has been operating enough time to remove the
moisture.
l
Make sure there are no curtains, blinds or furniture blocking the front or back of the
dehumidifier.
l
The humidity selector may not be set low enough.
l
Make sure you have cleaned the filter as suggested. Clogged filter may result in reduced
performance.
l
All house exits (windows doors etc) where the dehumidifier is operating, should be shut.
l
Room temperature is below the advised operational range.
l
There is a kerosene heater or something giving off water vapor in the room.
l
The room that the device is placed is bigger than suggested.
l
The humidity level is too high.
The unit makes a loud noise when operating
l
The air filter is clogged.
l
The device is tilted instead of being in an upright position.
l
The floor surface is not flat.
Frost build up on coils
l
This is normal. This unit is supplied with an Auto defrost feature.
Drain hose water leakage
l
Check the correct installation of the drain hose.
l
Check for any blockage or damage of the drain hose.
Understanding Error code indications
C1 - Defrost sensor failure
C2 - Humidity and temperature sensor failure
C8 - The temperature difference between defrost sensor and temperature & humidity
sensor detected ≤3ºC it maybe the refrigerant leakage.