SAFETY AND OPERATING MANUAL
28
202117 ROUTER 1500W
9. RATE OF FEED
It is important to move the router at the correct speed
throughout the work. The incorrect speed may produce
a poor quality cut. Moving too fast can cause bit
damage and a rough uneven cut.
A too slow speed can cause the wood to burn and the
bit to overheat. The rate of feed will vary depending on
the size of bit, material and router speed. To determine
the best speed always practice on a small unseen area
or a spare piece of the same material first.
10. USING THE ROUTER FREEHAND (See Fig. I)
NOTE:
As the router rotates in a clockwise direction
always move the tool in a left to right direction as you
stand facing your work. (See Fig. G)
When cutting an outside edge move the router
counterclockwise; and clockwise to cut an inside edge.
11. FITTING THE CENTERING PIN AND MAKING
CIRCULAR CUTS (See Fig. J1, J2, K)
The centering pin allows you to make circular cuts.
Remove the screw and the washers from the parallel
guide shaft (See Fig. J1). Push the centering pin onto
the shaft and fasten it in place with the thumb screw.
(See Fig. J2)
Place the centering pin against the material. Set the
required radius by adjusting the shaft of the parallel
guide and tighten the parallel guide locking screws. Fix
router in required depth with lock lever. Switch on the
machine. (See Fig. K) After releasing the plunge lock
lever, lower the machine slowly. Cut grooves, shoulders,
etc at a steady rate of feed, holding the machine with
both hands. When finished, raise the machine again
and switch off the machine.
Summary of Contents for 202117
