Fig. 8
Fig. 9
Fig. 11
Fig. 10
Fig. 12
STARTENT
ASSEMBLY
INSTRUCTIONS
14. Fasten the corners of the tent to the anchors with loosened up to
the maximum tensioning straps (Fig. 8).
15.
Put the pole together by sliding one element into the other except
pole crown (Fig. 9).
16.
Screw the pole crown with the black knob through an eyelet in
the top of the roof (Fig.10).
17. Depending on the type and hardness of the substrate, adjust
the length the anchor pin by screwing it in (Fig.11).
18.
Attach to the base the handle for lifting the pole (Fig.12).
19.
Insert the pole to the pole crown. Place the pole holding the handle
and pole tube. After placing check that the pole is vertical (Fig. 12).
20. Start stretching the fabrics using the tension straps with buckles.
Be sure to tighten the straps on the opposite sides and not in a row.
21. Sidewalls can be attached only before the canopy is completely
stretched. After attaching sidewalls, fasten metal rings at the bottom
corner with metal rings fastened to sidewalls. It prevents zip fasteners
of the sidewalls from tearing.
ASSEMBLING OF A STEEL POLE
(STARTENT NORMAL AND BIG
- SINGLE POLE TENT )
22. Perform points 14-21 as described above, the only difference is that
you should lift the incomplete poles e.g. without one tube. After settling
the incomplete poles lift them up obliquely one by one and add the
missing tubes. Put the pole bases back on.
ASSEMBLING OF A STEEL POLE
(STARTENT NORMAL AND BIG
- TWIN AND THREE POLE TENT )
www.inventini.com
EN
11
