ASSEMBLING OF INFLATABLE POLE
(STARTENT PASCAL NORMAL AND BIG)
Fig. 13
Fig. 14
Fig. 15
Fig. 17
Fig. 18
14. Fasten the corners of the tent to the anchors with loosened up to
the maximum tensioning straps (Fig. 13).
15. Open the bag with the pole, then take the pole out of the
bag and spread it towards the inside part of the tent. Then slip the
pole under the canopy (Fig. 14).
16. Fasten the carabiner attached to the end of the pole to the ring
sewn inside the tip of the tent (Fig. 15).
17. Make sure the pump valve is in the position CLOSE (Fig. 16).
18. Use the pump to inflate the pole until you feel it is completely taut
(you will hear the sound of the pump changing) (Fig. 17).
19. Disconnect the pipe from the pump from the pole, then turn the
pump off (otherwise the air will escape from the pole) (Fig.18).
20. Erect the pole by moving it under the canopy. Place the base of
the pole instead of the central spike of the measuring tool. (Take
out the spike before placing the pole). This step is easier when 1
person moves the pole and 2 person lifts the pole (Fig. 19).
Anchor the pole to the ground by inserting spike in to the rings
at the base (Fig. 20). If you assemble a tent with two or more poles,
for each pole repeat the steps described in points 14-19 for each pole.
21.
Start stretching the fabrics using the tension straps with buckles
(Fig. 21). Be sure to tighten the straps on the opposite sides and not
in a row.
22.
Fig. 19
Fig. 16
STARTENT
ASSEMBLY
INSTRUCTIONS
CLOSE
OPEN
Rys. 20
Rys. 21
Sidewalls can be attached only before the canopy is completely
stretched. After attaching sidewalls, fasten metal rings at the bottom
corner with metal rings fastened to sidewalls. It prevents zip fasteners
of the sidewalls from tearing.
STARTENT ASSEMBLY INSTRUCTIONS
12
