8
SYSTEM OVERVIEW
inVENTer PAX standard set
•
Installation and operating instructions
2
System overview
The inVENTer PAX ventilation system is designed for ventilating small dwellings, bungalows,
attics, residential homes and nursing homes, hotels and B&Bs, as well as bathrooms and utility
rooms. Furthermore, the ventilation system is a special solution in the case of greater need
for sound insulation, increased wind pressure and for buildings with thin walls. It is suitable for
installation in new buildings as well as for retrofitting in existing buildings.
The inVENTer PAX standard set consists of the following components:
• Main module with user interface
• Infrared remote control
• Wall duct (2 x insulated wall sleeve, 60 cm length)
•
Dust filter for outdoor air and extract air
• Silencer
• Plug-in connector
• PAX weather protection hood
The main module is installed as standard inside the extract air room on the inside of the exterior
wall. Over a wall duct inside the exterior wall it is connected to the exhaust air and outdoor air.
If it is not possible to mount the main module directly on the inside of an external wall, the out-
side air and exhaust air ducts must be made impermeable on site. Under certain conditions the
inVENTer PAX can be installed in the subceiling.
In order to ensure that the device does not interfere with other ventilation processes and that its
functioning is not affected by them, it must always be installed in its own wall sleeve. This must
not contain any obstructions or other objects that interfere with the airflow.
The ventilation system can supply several rooms simultaneously. A duct system to bypass
inside rooms and/or connect additional rooms is available as an option from inVENTer GmbH.
Note that the specifications of the airflow-pressure curve refer to the standard set. If the main
module is connected to an duct system, the air flow is reduced. Real values may be evaluated
based on the airflow-pressure curve.
Under certain conditions the inVENTer PAX can be installed over the roof. This must be realised
on site.
Features
•
Tailor-made solution for a pleasant ambience in offices, living rooms and bedrooms as well as
bathrooms and utility rooms.
•
Power savings due to integrated cross-flow heat exchanger.
•
Integral G4 dust filters for outdoor and extract air.
• Suitable for wall thicknesses between 100 mm and 600 mm.
•
Different operating modes for an individual ambient climate.
• Regulation of supply and exhaust air.
• Heat recovery with supplementary heating.
