Invasix BodyTite™ Service Manual DO600463F
0344
Page 28 of 52
Section 5 - System Operation
This section of the manual explains how to start the device, operate it and turn it off.
Device Start-Up
1.
Press Power switch to turn device on. The system loads the software and enters a self-test
mode. If any problem is detected during the test the error message will appear.
2.
Verify the following:
Display screen is active (Backlight is On)
Splash screen and progress bar appears
System goes into treatment screen and it is in Standby mode
Software version is displayed
Connected Hand piece type is allowed in hand piece menu
3.
Set treatment parameters using Up and Down keys
4.
Press OK key to switch into the READY mode.
5.
After the system is ready to use (Ready Mode). Step on footswitch to start treatment.
Troubleshooting
If cavity is not sealed then VACUUM message is shown and RF is not activated.
If no testing load is connected a “Bad Coupling” message will appear on the upper right
side of the screen
System Shutdown
To shutdown the system turn power switch off.
