TDX WHEELCHAIRS
38
Part No. 1114809
70
O
TAPER (FIGURE 4)
WARNING
Minimum ground clearance for footrest is 3-inches - otherwise personal
injury and damage may result.
1. Remove any accessory from
the footrest(s).
2. Remove the footrest from the
wheelchair. Refer to INSTALL-
ING/REMOVING FOOTRESTS
in this section of the manual.
NOTE: Lay the assembly on a flat sur-
face to simplify this section.
NOTE: Note the position of the spacers
before disassembly.
3. Remove the mounting screw and coved spacer that secures the lower footrest assembly.
4. Position the footrest assembly to the desired height.
5. Secure lower footrest assembly with existing mounting screw and coved spacer. Se-
curely tighten.
NOTE: Make sure spacers are positioned properly when reassembling so as not to damage the
frame mounting tubes.
6. Reinstall the footrest(s) onto the wheelchair. Refer to INSTALLING/REMOVING
FOOTRESTS
in this section of the manual.
7. Reinstall any accessory onto the footrest(s).
Mounting Screw
Heel Loop
Footrest
FIGURE 4 - FOOTREST HEIGHT
ADJUSTMENT - 70
O
TAPER
Coved Spacer
PHAL4A (FIGURE 5)
1. Loosen, but do not remove the lug bolt and locknut that
secure the lower footrest to the footrest support.
2. Reposition the lower footrest to the desired height.
3. Securely tighten the lug bolt and locknut that secure the
lower footrest to the footrest support.
4. Repeat STEPS 1-3
for the opposite side of the wheelchair
footrest, if necessary.
Footrest Support
Lower Footrest
Lug Bolt/Locknut
FIGURE 5 -
FOOTREST HEIGHT
ADJUSTMENT -
PHAL4A
SECTION 4
FRONT RIGGINGS
FRONT
RIGGINGS
All manuals and user guides at all-guides.com
