SECTION 12—WHEEL LOCKS/ANTI-TIPPERS
Part No 1125027
75
Solara
®
/Spree GT
™
Installing/Adjusting Anti-Tippers
NOTE: For this procedure, refer to FIGURE 12.6.
NOTE: A 1 ½ to 2 ¼ inch clearance between the bottom of the anti-tipper wheels and the floor
MUST be maintained at all times.
Installing the Anti-Tippers
1. Remove the anti-tippers from the accessory carton.
WARNING
Anti-tippers MUST be fully engaged and spring buttons fully protruding out of
adjustment holes.
2. Press the release buttons in and install the anti-tippers with the wheels facing down
until the locking buttons lock in place (FIGURE 12.6).
3. Adjust the anti-tippers. Refer to Adjusting the Anti-Tippers on page 75.
Adjusting the Anti-Tippers
1. Depress the release button on the wheeled portion of the anti-tipper and slide it
up/down to achieve
1 ½ to 2 ¼ inch
clearance.
WARNING
Anti-tippers MUST be fully engaged and release buttons fully protruding out of
same respective adjustment holes BEFORE use. This will avoid a 3-Wheeling
situation.
2. Ensure that the release buttons are fully engaged in the adjustment holes and 1 ½ to 2
¼ inch clearance is maintained.
3. If a 1 ½ to 2 ¼ inch clearance cannot be obtained, contact a qualified technician.
4. Repeat STEPS 1-3 for opposite side.
FIGURE 12.6
Installing/Adjusting Anti-Tippers
Release Button
Anti-tipper
Locking
Button
Wheelchair
Frame
Release Button
Anti-tipper
(Wheeled Portion)
