SECTION 12—ELECTRONICS
Part No. 1122145
69
Pronto
®
M94
™
SECTION 12—ELECTRONICS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the OFF position.
REPOSITIONING THE JOYSTICK
ADJUSTABLE SEAT BACK ANGLE (ASBA) MODEL
NOTE: For this procedure, refer to FIGURE 12.1.
1. Turn the lever on the adjustment lock to release the adjustment lock from joystick
mounting tube.
2. Remove the joystick from the wheelchair.
3. Remove the three (3) hex screws that secure joystick mounting bracket, the threaded
hole half clamp and the opened hole half clamp to the arm tube.
4. Reposition the threaded hole half clamp and opened hole half clamp on the opposite
arm tube. Make sure threaded hole half clamp is on the inside of arm tube.
5. While holding the two (2) half clamps, install the front hex screw into the two (2) half
clamps. Securely tighten.
6. Line up mounting holes of the joystick mounting bracket with the mounting holes in
the two (2) half clamps.
7. Secure the joystick mounting bracket to the two (2) half clamps with the remaining
two (2) hex screws.
8. Slide tube through the bracket to the desired position.
9. Slide adjustment lock over end of tube and secure adjustment lock to tube by turning
lever on adjustment lock.
NOTE: If adjustment lock does not fit over tube, rotate 180°.
