SECTION 5—WHEELCHAIR OPERATION
Part No. 1122145
33
Pronto
®
M94
™
MPJ JOYSTICK SWITCHES AND INDICATORS
NOTE: Refer to FIGURE 5.4 for the following information.
NOTE: The MPJ joystick must be used with the MK5 EX controller.
FIGURE 5.4 - MPJ JOYSTICK SWITCHES AND INDICATORS
DRIVE SELECT TOGGLE SWITCH
A three (3) position drive select toggle switch is located on the display module in the
lower right corner. The drive select position is momentary.
This switch allows the operator to select the type of operation or performance which best
suits a particular control need or situation. The DRIVE 1 program uses performance
values which are independent of those used for the DRIVE 2 or 3 or 4 program. As an
example, an operator may have a control need for spasticity in the morning and a very
different need in the afternoon. DRIVE 1 can be programmed for higher speeds and
quicker response while DRIVE 2 can be programmed for slower speeds and less
responsiveness or vise versa. The other two drive programs could be indoor and outdoor
versions of DRIVE 1 and DRIVE 2.
SELECTING THE DRIVE MODE
1. Move the toggle Up and release. DRIVE 1 will appear on LCD.
2. Move the toggle UP and release again. DRIVE 2 will appear on LCD.
3. Move the toggle UP and release again. DRIVE 3 will appear on LCD.
4. Move the toggle UP and release again. DRIVE 4 will appear on LCD.
5. Move the toggle UP and release one more time to select DRIVE 1.
Joystick
Remote On/Off Input
Optional Drive Select Input
To Controller
On/Off/Drive Select Toggle Switch
LCD
Speed Control Switch
Charger/Programming Input
