SECTION 5—INITIAL SETUP
Invacare® Polaris™EX™
20
Part No 1110559
SECTION 5—INITIAL SETUP
1. Place the unit and accessories in a stable, clean, dry
location near a 120 VAC
(60 Hz) electric outlet.
WARNING
DO NOT leave long lengths of tubing around the top of
the bed or pillow. This tubing could twist around your
head or neck while sleeping.
2. Ensure the Polaris EX CPAP unit is positioned close
enough to allow slack in the tubing and that the air filter
intake vent at the rear of the unit is not obstructed.
3. Connect one end of the air tubing to the Polaris EX CPAP
unit air outlet.
NOTE: Refer to the mask and headgear instructions for their
assembly.
NOTE: If a humidifier is prescribed for use, refer to the humidifier
manual for assembly instructions.
4. Plug the Polaris EX CPAP unit power cord into a nearby
120 VAC
(60 Hz) power outlet.
NOTE: DO NOT use extension cords.
WARNING
To ensure proper operation of the compliance clock, the
Invacare Polaris EX CPAP should be left plugged in for 12
hours after initial programming.
5. If no button has been pressed for 30 seconds, the display
intensity will diminish. Pressing any button after the
display dims will reactivate the brighter display.
NOTE: Heated humidifier on/off button reactivates the brighter
display only if the heated humidifier is installed.
