SECTION 6—FRONT RIGGINGS
P9000
™
XDT
34
Part No. 1118386
FIGURE 6.1
Installing/Removing/Using the Footrest/Legrest
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
Adjusting the Footrest Height
NOTE: For this procedure, refer to FIGURE 6.2.
NOTE: This procedure applies to the swingaway footrest and elevating legrest.
1. Remove the swingaway footrest assembly. Refer to Installing/Removing/Using the
Footrest/Legrest on page 33.
NOTE: Lay the assembly on a flat surface to simplify this procedure.
2. Remove impact guards and/or calf strap, if installed.
3. Pull the cam lock lever up to the unlocked position.
4. Push in the release buttons and reposition the lower footrest assembly to the desired
height.
5. Ensure that the release buttons fully protrude from holes on both sides of the upper
footrest support.
6. Rotate cam lock lever down to locked
position.
7. Replace impact guards and/or calf
strap.
8. Repeat this procedure for the other
footrest, if necessary.
9. Reinstall the swingaway footrest
assembly. Refer to
Installing/Removing/Using the
Footrest/Legrest on page 33.
FIGURE 6.2
Adjusting the Footrest Height
Hinge
Pins
Hinge
Plates
Footrest
Release Lever
Swingaway
Footrest
Assembly
Footplate
Adjustment
Holes
Cam Lock Lever
Upper Footrest Support
Release Button
Lower Footrest
Assembly