The legrest with foot platform is adjusted the same
way.
10.3.8 Setting Angle of Foot Plate
•
5/32 inch Allen key
Fig. 10-24
1.
Fold the foot plates up in order to access the adjusting
screws (1).
2.
Set the adjusting screws using the Allen key.
3.
Fold the foot plate down again.
10.3.9 Adjusting footplate width of
center-mounted legrest
The footplate width is adjusted via spacers:
•
Set spacers on the inside to increase width.
•
Set spacers on the outside to decrease width.
Each spacer increases or decreases the width by 1/4”
(6.35 mm).
Tools:
•
6 mm Allen key
1.
Remove screw
A
.
2.
Remove spacers
B
and footplate.
3.
Set spacers on the inside as needed.
4.
Add footplate.
5.
Set spacers on the outside as needed.
6.
Retighten screw.
10.3.10 Setting Angle of Footboard
•
5/32 inch Allen key
Fig. 10-25
1.
Fold the foot platform up in order to access the
adjusting screw
A
.
2.
Set the adjusting screw using the Allen key.
3.
Fold the foot platform down again.
10.3.11 Setting Height and Width of Calf Pad
Risk of damage to the mobility device
– After changing the configuration of the calf
pads make sure that the calf pads contact
neither the casters nor the seat plate when
adjusting the legrest angle.
Calf pads may be adjusted independently on their
respective mounting bracket using the mounting screws at
the rear of the calf pads. Calf pads may be adjusted (for
depth, height & angle) to achieve a variety of different
configurations. The independent pad adjustments provide
optimal positioning and comfort for end users - sample
configurations are illustrated below.
Calf Pad Adjustment — Sample Configurations
Centered
Extended
Position
(maxi-
mum)
Lowered
Offset
Raised
Offset
Angled
•
4 mm Allen key
1.
Fold the calf pad forward in order to access the bolts.
2.
Loosen the bolts and remove them if necessary.
3.
Adjust the calf pad to the required height and width.
4.
Retighten the bolts.
5.
Fold the calf pad back.
10.4 Vari-F footrest
10.4.1 Swivelling the footrest/legrest outward
and/or removing
The small unlocking button is located on the upper section
of the footrest/legrest. When the footrest/legrest is
1586649-F
71
Summary of Contents for Motion Concepts Ultra Low Maxx
