SECTION 2—OPERATION
MA90 Series
10
Part No 1148139
SECTION 2—OPERATION
CAUTION
The control unit and mattress on the MA90Z series are designed to be used as a
system. DO NOT replace mattresses or control units with other models or other
brands. Otherwise, damage to the system may occur. Contact your supplier to get
the correct replacement if needed.
Installing the Mattress Replacement System
CAUTION
DO NOT strap the mattress to the bed frame at the head and foot ends. Secure
ALL mattress straps. Secure the straps to the bed deck at the head and foot ends
and to the frame at the center of the bed. Otherwise damage to the mattress will
occur when the head and foot ends are raised.
NOTE:
For
this
procedure,
refer
to
FIGURE 2.1.
NOTE:
The
powered
mattress
comes
with
ten
nylon
buckle
straps.
1. Remove
the
original
foam
mattress
from
the
bed.
2. If
necessary,
lower
the
side
rails
to
facilitate
installation
of
the
mattress.
3. Unroll
the
powered
mattress
and
place
it
on
the
bed
frame.
NOTE:
Ensure
that
the
hose
is
towards
the
foot
end
of
the
bed.
4. Use
the
buckle
straps
to
secure
the
powered
mattress
to
the
bed
deck
in
the
following
locations:
• Head
End
‐
Head
End
Bed
Deck
• Foot
End
‐
Foot
End
Bed
Deck
• Center
‐
Center
of
the
Bed
Frame
Center of Bed Frame
Head End Bed Deck
Foot End Bed Deck
DO NOT Strap Here
