SERVICE MANUAL
Invacare
®
- Kite
62
8.7.8
Replacing the complete tail light assembly (conventional lighting system)
Requirements:
•
8 mm socket wrench
Uninstalling the tail light:
•
Switch the electronics OFF on the remote.
•
Remove the rear cover, as described in chapter 8.1.1.
•
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
•
Disconnect the cable of the affected tail light from the lighting circuit board.
•
Remove both plastic covers (1).
•
Use the 8 mm socket wrench to loosen both nuts (2).
•
Remove the nut and the washers (3).
•
Pull the tail light (5) towards the rear and off and remove both bushings (4).
Installing the tail light:
•
Assemble all parts again in reverse order.
•
Tighten the screws hand-tight.
•
Check all vehicle functions.
