Part No 1143214
5
ICCI Bed Rails and Accessories
Installing/Using the Carroll
Assist Rail
®
and Carroll Assist Bar
Installing/Using IHRAILAB-DL and IHRAILAE-DLX
For instruction involving installation and use of the Carroll Assist Rails and Carroll Assist Bar, refer to the instruction
sheet included with the rails.
Installing/Using the ThinkSoft®Positioning Device
WARNING
DO NOT use this product or any available optional equipment without first completely reading and
understanding these instructions and any additional instructional material such as owner’s manuals, service
manuals or instruction sheets supplied with this product or optional equipment. If you are unable to understand
the warnings, cautions or instructions, contact a healthcare professional, dealer or technical personnel before
attempting to use this equipment - otherwise, injury or damage may occur.
This device is intended to provide a grip surface to a bed occupant to position themselves.
DO NOT use for restraint purposes.
DO NOT use this device as a push handle for moving the bed.
ALWAYS test to make sure that this device is properly and securely in place before using.
Although this device is not rated to any specific weight limitation, this device may become deformed or broken
if excessive side pressure is exerted on this device.
Installing the IHRAILTS-DLX Positioning Device
NOTE: For this procedure, refer to FIGURE 6 and FIGURE 7.
1.
When installing the positioning device IHRAILTS - DLX on a bed used with an 80-inch mattress, the head board
mounting brackets and mattress keepers MUST be adjusted. Refer to Changing the Head Board Mounting Position
and Changing the Mounting Position of the Mattress Keepers on page 7.
2.
Raise the mattress deck to which the positioning device will be attached.
3.
Locate the proper mounting holes on the bed to install the positioning device (FIGURE 6).
FIGURE 6
Mounting Holes for Mounting Bracket
4.
Position the mounting bracket on the mattress deck (FIGURE 7).
5.
Secure the mounting bracket to the mattress deck with the two hex bolts and locknuts (FIGURE 7).
6.
Install the positioning device into the mounting bracket by sliding the mounting pin of the bed rail through the
pivot tube (FIGURE 7).
7.
Secure positioning device in place with two retaining clips (FIGURE 7).
NOTE: Ensure that the release lever is pointing towards the foot end of the bed.
8.
Slide the nylon washer over the end of the mounting pins (FIGURE 7).
9.
Snap retaining clips into grooves on the end of the mounting pins (FIGURE 7).
10. Head End Mounting Bracket Only - Position the crossmember between the two bed rails (FIGURE 7).
NOTE: Repeat STEPS 3-9 to install the other positioning device on the opposite side.
Head End
Mounting Holes for
Mounting Bracket
8th Mounting Hole
5th Mounting
Hole
1st
Mounting
Hole
