ICCI Bed Rails and Accessories
2
Part No 1143214
FIGURE 1
Installing 6801A and 6808A Bed Rails
4.
Install a socket screw into the head end and foot end mounting pins and tighten securely.
5.
Securely tighten the hex bolts and locknuts that secure the pivot brackets to the bed frame.
6.
Repeat STEPS 3-6
for the opposite bed rail.
Installing 6815A, 6816A and 6803A Bed Rails
NOTE: For this procedure, refer to FIGURE 2.
1.
When installing bed rails 6815A, 6816A or 6803A on a bed used with an 80-inch mattress, the head board mounting
brackets MUST be adjusted. Refer to Changing the Head Board Mounting Position on page 6.
2.
Raise the mattress deck to which the bed rail will be attached.
3.
Locate the proper mounting holes on the bed to install the bed rails. Refer to Detail “B” of FIGURE 2.
4.
Position the mounting bracket on the mattress deck. Refer to Detail “B” of FIGURE 2.
5.
Secure the mounting bracket to the mattress deck with the two hex bolts and locknuts.
6.
Install the bed rail to the mounting bracket by sliding the mounting pin of the bed rail through the pivot tube.
NOTE: Ensure that the release lever is pointing towards the foot end of the bed.
Release Lever
DETAIL “B” - FOOT END TOP VIEW
DETAIL “A” - HEAD END TOP VIEW
Bed Rail (on the outside of bed
frame)
Bed Frame
Bed Rail (on the outside of bed frame)
Crossmember
Inside of Bed
Frame
Socket Screw
Pivot Tube
Mounting Pin
Socket Screw
Mounting Pin
Bed Rail (on the
outside of bed
frame)
Pivot Bracket
Hex Bolt and Locknut
Pivot Tube
Pivot
Bracket
Hex Bolt and
Locknut
Inside of Bed
Frame
See Detail B
See Detail A
