4.15 Determining/Setting Toe In/Toe Out
1.
Inflate all pneumatic tires to recommended tire pressures (listed
on the sidewall of the tire).
2.
Measure the distance between the centerlines
A
at the rear and
front of the rear wheels at approximately 12 inches (30.48cm)
[for 24-inch (60.96cm)diameter wheels] from the ground/floor
B
.
3.
Determine difference between two measurements. If difference
between the two measurements is greater than 1/8 inch, one
of two conditions exists:
•
If the back centerline measurement of the rear wheels
C
is
SMALLER
E
than the front centerline measurement of the
rear wheels
D
, a TOE-OUT
F
condition exists
•
If the back centerline measurement of the rear wheels
C
is
LARGER
G
than the front centerline measurement of the
rear wheels
D
, a TOE-IN
H
condition exists
4.
If the difference between the measurements is greater than
1/8-inch (0.32cm), correct the toe-in/toe-out condition by
performing the following:
a.
Loosen both mounting socket head clamp screws
b.
Rotate the camber tube until front and rear measurement
are within 1/8-inch
c.
Securely tighten both socket head clamp screws
Top
View of
Wheel-
chair
Top View of
Wheelchair
1134872-D~08
51
Summary of Contents for Crossfire All Terrain
Page 17: ...Overview 3 Overview 3 1 Label Locations 1134872 D 08 17 ...
Page 87: ...Notes ...
