Service
6.
Remove screw
B
that fixes shroud between front
wheels.
7.
To check position of sensors of curve control device, use
measuring gauge
A
supplied in “Bend speed reducer
retrofitting kit”.
Replacing sensors (5) without mounting
1.
Loosen screws (2).
2.
Replace sensor.
Replacing sensors (5) with mounting
1.
Loosen fork bolt (1).
2.
Replace sensors (5) with mounting.
Replacing regulating unit (4)
1.
Loosen screws.
2.
Remove sensor (5).
3.
Loosen screws (3).
4.
Replace regulating unit (4).
Adjusting
1.
Set steering to straight ahead.
2.
Align sensor straight using regulating unit.
3.
Take hold of the sensor and tighten the fork screw.
Check
1.
Turn steering completely to right and then left.
2.
When steering is turned to its limit, the 3 regulating unit
switches should be visible.
3.
Install parts in reverse order.
4.
Check functions (trial run).
4.10 Drive components
4.10.1 Replacing drive unit
CAUTION!
Risk of accident
When parking mobility device on antitippers it is
no longer slowed by motor brake. Mobility device
can roll away out of control.
– Place mobility device rear frame on a supporting
wooden block before you remove wheels.
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note the position of small parts
such as screws and washers. Put small parts down so
that they can be reassembled in the right sequence.
The plugs on the power module cannot be wrongly
connected because all plugs have a different size and
only fit in one socket.
•
10 mm wrench
•
17 mm wrench
•
Oblique pliers
•
Rubber hammer
•
Phillips screwdriver
•
Supporting wooden block
•
5 mm Allen key
•
Thread locking adhesive (for example Locktite
243)
1.
Secure mobility device against rolling away.
2.
Place supporting wooden block under the frame at
battery holder height.
3.
Remove seat.
4.
Remove shroud.
5.
Disconnect battery cable
A
.
6.
Unscrew rear wheel fixing bolts.
7.
Remove rear wheels.
8.
Cut cable ties.
1603798-B
29
