4. Installation Procedures
72
Panel Antenna
,
Continued
Panel antenna installation procedure
, continued
Step
Action
2
Radio unit and antenna should be adjusted for common polarization. If the
LINK
polarization is
HORIZONTAL
then the feeders should be remained, as shown
below:
If the
LINK
polarization is
VERTICAL
, use the allen key to loosen the four screws
at the waveguide port of the radio (do not remove the screws) and then
TURN
the
polarizer, as shown below:
The terminal station polarization at 10.5 GHz (radio-panel antenna) is specific and
applicable to this case only.
Do not over tighten the screws. Apply maximum tightening torque 0.6 Nm.
The misalignment of slots between the movable part and the stationary part of the radio
waveguide port is intentional and does not indicate a problem.
Continued on next page
