ITABAR Flow Sensor Type
IBF
Operating
Manual
Fig. 12
7. For sensor end support with sealing plug
only:Seal the thread of the sealing plug with a
suitable sealing compound (e.g. PTFE tape). Screw
the sealing plug into the sensor end support and
tighten it firmly.
Fig. 12a
8. Perform the installation of the sensor into the pipe
according to the instructions given in chapter 6.1.
6.3 Installation of Type IBF-25
1. Drill a hole of 35mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-20 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
6.4 Installation of Type IBF-26
1. Drill a hole of 35mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-21 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
6.5 Installation of Type IBF-35
1. Drill a hole of 40mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-20 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
6.6 Installation of Type IBF-36
1. Drill a hole of 40mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-21 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
6.7 Installation of Type IBF-65
1. Drill a hole of 60mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-20 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
6.8 Installation of Type IBF-66
The design of the ITABAR sensor of the type IBF-
66 is almost identical to the type IBF-21. The only
difference is the sensor end support (delivered in
two pieces). After successful installation of the end
support, the end cap must be weld onto the end
support.
1. Drill a hole of 60mm diameter into the pipe.
The subsequent Stepps correspond to the installation
of the ITABAR sensor type IBF-21 !
Oberserve the H- dimension during the welding!
(see also Fig. 9)
Note !
On long sensors, an installation aid can be screwed
into the ½” thread of the sensor end (e.g. threaded
pipe). This will make it easier to insert the sensor
into the opening of the sensor end support and align
the sensor.
7. Installation of the Attachments and the
∆
p-Transmitter
7.1 Instrument
valves
The instrument valves for the differential pressure
lines are pre- installed by the manufacturer, if it is
part of the order.
7