Mechanical installation
Kendrion INTORQ | BA 14.0223 | 04/2022
22
5
Mechanical installation
This chapter provides step-by-step instructions for the installation.
Important notices and information
NOTICE
The toothed hub and screws must not be lubricated with grease or oil.
5.1
Design of end shield and shaft
¾
Comply with the specified minimum requirements regarding the end shield and the shaft to ensure a
correct function of the brake.
¾
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
¾
The form and position tolerances apply only to the materials mentioned. Consult with Kendrion IN-
TORQ before using other materials; written confirmation is required for such usage.
¾
If a friction plate is used as a counter friction surface, the customer must ensure that it is fully sup-
ported by the motor end shield.
¾
Depending on the type of installation, additional clearing bore holes may be required.
¾
Keep the end shield free from grease or oil.
Minimum requirements of the end shield
Size
Material
1) 2)
Roughness
2)
Run-out
Levelness
Tensile strength R
m
[mm]
[mm]
[N/mm
2
]
06
S235JR; C15;
EN-GJL-250
Rz6
0.03
< 0.06
250
08
0.03
10
0.03
12
0.05
Tab. 6:
End shield as counter friction surface
1)
Consult with Kendrion INTORQ before using other materials.
2)
When
no
brake flange or friction plate is used.
